Hello!

I had tough time removing the rotors from the front. Spent several hours of banging after PB treatment to no avail. Used the bolt method to press on the rotor to get it off. Worked! However, it seems to have pushed the "ear" of the knuckle towards inside by 2mm. So, front of the rotor is rubbing against the caliper bracket. Used 3MM steel washer as spacer between the bracket and the "ear" and it seems to be fine. I am planning to replace it with 2MM washer and also apply red loctite on the bolt for "final" assembly.

Is this okay ? Should I replace the while knuckle ?

Thanks in advance!