Search:

Type: Posts; User: Brad'sBB

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. Replies
    8
    Views
    9,502

    Thanks all. Going to get the Vida Dice on Ebay.

    Thanks all. Going to get the Vida Dice on Ebay.
  2. Replies
    8
    Views
    9,502

    Thanks. I will try the reboot as the closest...

    Thanks. I will try the reboot as the closest dealer is 3 hours away. I was looking to purchase a scan tool. Was thinking of a carsoft i906. Anyone use or have one? Any other scan tools that you folks...
  3. Replies
    8
    Views
    9,502

    OK finally got a chance to check the voltage at...

    OK finally got a chance to check the voltage at the headlight bulb plug. With the engine running and or the light switch on or off I had .05 volts. I measured it between the plug terminals and also...
  4. Replies
    8
    Views
    9,502

    Thanks, will check and post back.

    Thanks, will check and post back.
  5. Replies
    8
    Views
    9,502

    Headlight problem.

    Hi all
    The driver's side dim headlight went out. Purchased a new one and installed it. The new bulb also didn't work. The dash message center indicates bulb failure. Checked the fuses, all good....
  6. Replies
    3
    Views
    2,739

    Thanks got it filled. Drove it around a bit. Put...

    Thanks got it filled. Drove it around a bit. Put it up on blocks to level it. Took plug out and some fluid ran out. Waited till it was dripping. Pulled between 40 - 50 ml out. Still have to measure...
  7. Replies
    3
    Views
    2,739

    Haldex oil level

    OK finally got a chance to change out the haldex oil in the 2004 xc. Was injured working, finally recovered enough to crawl under the car. Lol.
    Seems there is different information on the oil...
  8. No, not the bolts/ screws on the DEM . The small...

    No, not the bolts/ screws on the DEM . The small bolts that hold the Haladex filter cap /cover on. I believe I have version 2 of the Haladex. The top bolt of the cover is almost impossible to...
  9. OK, got the Haladex cleaned. Was going to...

    OK, got the Haladex cleaned. Was going to attempt to change out the filter. Got a 4mm x 1/4 hex bit and low an behold, another person had stripped out the hex hole on the lower bolt or it was...
  10. Thanks, I did find the plug. I live off grid and...

    Thanks, I did find the plug. I live off grid and the car travels about 8 miles of dirt road to get to town. During the winter and monsoon periods of summer the mud is terrible. The plug was hidden by...
  11. Thanks, I did locate the Haladex. Wasn't sure if...

    Thanks, I did locate the Haladex. Wasn't sure if the fill plug was on the unit or further back. One writeup showed it being close to the differential plug. My main concern was that both differential...
  12. Thanks, I did locate the Haladex. Wasn't sure if...

    Thanks, I did locate the Haladex. Wasn't sure if the fill plug was on the unit or further back. One writeup showed it being close to the differential plug. My main concern was that both differential...
  13. Thank you

    Thank you
  14. Pic link disappeared. Edited and now the link is...

    Pic link disappeared. Edited and now the link is again there.
  15. pictures

    Here are a few pics of the rear side of the diff. There are 2 bolts/plugs. One on the left is larger, one on right is barely visible. Which is the diff plug ?
    ...
  16. I am going out right now and taking a few...

    I am going out right now and taking a few pictures. I looked at several tube vids and read several write ups. Did the angle gear. The fill plug on it was facing the passenger side instead of the rear...
  17. Real time 2004 xc70 differential fill plug location needed

    Hi all
    Drain/fill plug location needed for rear differential. . Searched, found several pictures, but none look like mine. All are either earlier or later. I read it is in the rear, there is what...
  18. Thread: Exhaust leak

    by Brad'sBB
    Replies
    8
    Views
    3,082

    Wife took the car the other day to the muffler...

    Wife took the car the other day to the muffler shop. Guy there, figured 2 hours of labor to fix. This was after having it up on the lift. That seems to be less work then what would be required if the...
  19. Thread: Exhaust leak

    by Brad'sBB
    Replies
    8
    Views
    3,082

    Wife took the car the other day to the muffler...

    Wife took the car the other day to the muffler shop. Guy there, figured 2 hours of labor to fix. This was after having it up on the lift. That seems to be less work then what would be required if the...
  20. Thread: Exhaust leak

    by Brad'sBB
    Replies
    8
    Views
    3,082

    Exhaust leak

    Well the 04 has developed an exhaust leak. From looking and listening, it appears to be either at the down tube connection where it bolts onto the turbo, or possibly a hole in the tube. My questions...
  21. Replies
    1
    Views
    903

    Got it back together. Used a ratchet strap to...

    Got it back together. Used a ratchet strap to pull the trailing arm towards the front of the vehicle. Still have not figured a way to remove the bushing and replace. If if I figure out a tool and it...
  22. Replies
    1
    Views
    903

    Murphutrailing arm bushing

    Hi all
    Been a Murphy couple weeks
    Well got some new rear shocks the other day. Went to put them on . Got the passenger side done. Pita but figured the other side would be easier. Got it figured out...
  23. Replies
    2
    Views
    941

    Hi Thank you. The bolt was missing. Got a new...

    Hi
    Thank you. The bolt was missing. Got a new metric one as a temp from hardware store. Ordered a pair of new ones.
    Best Regards
    Brad
  24. Replies
    2
    Views
    941

    Front axle/ cv question

    Hi all
    Was under my 2004 and noticed the passenger side axle seems loose. As in it moves in and out. Checked the drivers side and no movement. What holds the front axle to the hub? Does it float or...
  25. Replies
    8
    Views
    1,664

    That was the problem. Thanks all. The one end of...

    That was the problem. Thanks all. The one end of the link on the side making noise was good, other end was shot .
Results 1 to 25 of 51
Page 1 of 3 1 2 3