No UPDATE / CANCEL Option After Verifying VIN

[Oka]

With my other two 01 XC70s, whenever I scan them, after the tool finishes Verifying VIN, I always get the option to "UPDATE" OR "CANCEL". With this XC90, and the first scan, I did not get either option. Just a side note, with the XC70s, I always run the engine to keep the battery, but did not on this XC90, though, I had the key to position II. Since it was the first scan, I would have liked to clear all, drive it a bit and scan again, "CANCEL". What's going on here with the scan?

Cheers

[Oka]

With my other two 01 XC70s, whenever I scan them, after the tool finishes Verifying VIN, I always get the option to "UPDATE" OR "CANCEL". With this XC90, and the first scan, I did not get either option. Just a side note, with the XC70s, I always run the engine to keep the battery, but did not on this XC90, though, I had the key to position II. Since it was the first scan, I would have liked to clear all, drive it a bit and scan again, "CANCEL". What's going on here with the scan?

Cheers

Please disregard this post. I found out I had to re-scan to get the option to update.
Thanks.