Results 1 to 5 of 5
  1. #1
    Join Date
    Oct 2007
    Posts
    8

    Default Oil consumption 2016 XC 70 T5

    Took over wifeís XC 70 around 50 k, and now has 90k. Always did factory recommended services at dealer. Never noticed oil consumption problem until recently (probably starting)around 80k. Oil pressure light came on driving near auto parts store and could believe how much oil I had to add to get back up to top level (nearly 4 qts.)😖 it was my fault for not regularly checking level, but never had problem before. Lesson learned -always check oil regularly. I thought there would be a light that would come before getting that low? Iíve been monitoring oil since and burning about 1qt.per 1k. Took into dealer recently for regular service and they only pulled a spark plug and added BG oil additive product, and replied theyíre no engine codes. Out of warrantee and donít care to deal with them any longer. After reading about burning oil, could be varnished/stuck rings, worn rings, PCV, Valve seals, or...? after doing some research. Iím thinking doing BG platinum fuel additive to clean fuel system and combustion chamber, then do BG EPR engines clean and possibly unstick rings back to normal. Iíll be doing my own oil changes from now on, but every 5-6 k. If the flush doesnít seam to help, Iíll get her checked over by an independent mechanic. Has anyone ever tried BG EPR, or experienced varnished/stuck rings? I read that engines now days are more prone to this problem especially with such long oil change intervals. Thanks for any tips or advice. Love the car and trying to make it last.

  2. #2
    Join Date
    Dec 2009
    Location
    GA
    Posts
    1,320

    Default

    Quote Originally Posted by Mark2112 View Post
    now has 90k.

    1. Always did factory recommended services at dealer.

    2. Oil pressure light came on I thought there would be a light that would come before getting that low?

    3. burning about 1qt.per 1k.

    4. dealer added BG oil additive product,

    5. After reading about burning oil, could be varnished/stuck rings, worn rings, PCV, Valve seals, or...?

    6. Iím thinking doing BG platinum fuel additive

    7. then do BG EPR engines clean

    8. Iíll be doing my own oil changes from now on, but every 5-6 k.

    9. If the flush doesnít seam to help, Iíll get her checked over by an independent mechanic.

    10. Has anyone ever tried BG EPR,

    11. I read that engines now days are more prone to this problem especially with such long oil change intervals.
    1. 10k between oil changes is usually too long for most driving conditions.

    2. There is no oil level sensor, just oil pressure. (and oil level sensors fail in the engines that have them)

    3. Unfortunately expect your engine to continue with that usage.

    4. And took x dollars from your wallet

    5. Could be - if PCV system was incorrectly regulating "oil fume" flow, you would usually get a code or some other symptom (high vacuum in crankcase), worn valve seals certainly can cause increased oil usage, none are inexpensive to fix other than pcv system.

    6. Don't try any more additives, unless you just like to throw money away.

    7. Same as previous comment, there is no such thing as a "tune up in a can" and anything that thins oil out is not a good idea. My BG salesman used to try to sell me all that stuff.

    8. Frequent oil changes with a quality oil/filter are a very good idea.

    9. OK - maybe he will sell you a magic additive also, or even a valve job or engine rebuild! (there nothing cheap to fix/check if there are no external leaks)

    10. No, as you can tell I don't like additives, although in the early 80's-90's, Techron or the BG fuel product was needed until injector and gasoline makers got their act together and made products that did not clog.

    11. Yes and direct injection has created new problems.

    I have seen many oil burning Volvo engines over the years - they usually were owned by timid drivers, those that never ran the engines hard - so possibly using the entire RPM range with full throttle sometimes might help -

  3. #3
    Join Date
    Aug 2017
    Location
    Pleasanton CA USA
    Posts
    404

    Default

    Curious to know if this 2016 "T5" has one of the early 4 cyl. Drive-E engines. Is it FWD? 8-speed Geartronic? Direct fuel injection?
    Last edited by pbierre; 02-15-2020 at 05:56 AM.
    2013 XC70 T6 Flamenco Red (hers)
    2015 XC70 T6 Seashell Metallic (his)
    past: 13 Volvos going back to '74 242 sedan

  4. #4
    Join Date
    Oct 2007
    Posts
    8

    Default

    Not sure, maybe to unload engines ? This was the last model year for XC70 -ordered it and was made in Sweden. Our previous 2013 Xc70 was 6 cylinder and is still going strong with mother in law driving. Iím going to use BG 109 EPR soon to clean the engine out of gunk & varnish to see if there is any improvement. Anyone else ever use this or Auto RX?

  5. #5
    Join Date
    Oct 2007
    Posts
    8

    Default

    Well, I added BGs 44kplatinum to clean fuel system, and seemed to make immediate impact on throttle response and felt peppy. Then I added BGs EPR to old oil let car rev around 1200-1500 rpm for about 17 minutes, drained/ replaced filter. Oil was black. Put in cheaper synthetic 5w-30 and drove forvabout 20 minutes, then drain that/replaced filter to get more of EPR out. Oil was black again at first but then turned lighter as oil ended itís draining. Put Castrol5w-30 synthetic in and new filter, along with BG MOA. Dip stick shows clear clean oil-even hard to see level so clear. Only time will tell if oil consumption improves. Hard for me to know if compression is up , but sure seems to sound and drive nicely.👍 Iíll let you know what I find with consumption in few weeks.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •