Results 1 to 2 of 2
  1. #1
    Join Date
    Aug 2007
    Location
    NJ
    Posts
    639

    Default 3D Printing help? - OT

    This is an Off Topic post but I am trying to find someone who can help me create a part for a project car I have. I have mocked up a gauge cluster and wanted to see if someone could print it for me. Here is the link below to the details.

    Thanks!

    http://nastyz28.com/threads/3d-printing-anyone.327432/
    2020 Subaru Outback XT - Pearl White Loaded-huge improvement over 2013!
    1955 Ford F-250 - 223 IL6, 4 Speed with Granny Gear, 109 HP, 4.88 Rear
    2017 Maserati Ghibli - Blu Emozione - GONE!
    2013 2013 Subaru Outback - charcoal Grey, Eyesight Collision Avoidance 110k miles
    2007 2007 XC70, Barents Blue, Charcoal Leather 215k miles
    1978 Bitchin' Chevrolet Z28 Camaro - Fuel Injected 383ci SB Dyno'd at 452HP 462FT/LBs Torque
    My build thread: http://www.nastyz28.com/forum/showthread.php?t=276139

  2. #2
    Join Date
    Aug 2017
    Location
    Pleasanton CA USA
    Posts
    486

    Default

    There are plenty of remote prototyping services available online. You're in NJ, so you might just search around for a 3D printing course, where you get to do a project. Developing a new printed part is often an iterative process, especially if it has to integrate mechanically.
    2013 XC70 T6 Flamenco Red (hers)
    2015 XC70 T6 Seashell Metallic (his)
    past: 13 Volvos going back to '74 242 sedan

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •