Hello All,
Recently purchased a square profile roof rack bars for a 2013 XC70. Dealership parts dept. had it discounted due to box missing ($115 tax included). Received the two bars, a set of keys for the locks and instructions.
Tried to install today, but ran into a problem. I couldn't get the "clips" to tighten onto the roof rails. Investigated further, I removed a small plastic tab next to the key hole, and found a torque bit/head. By rotating this torque bit the "clip" would tighten. Had to use a pair of needle nose pliers to tighten however. Do not want to strip this bit/head. So I figure this is how you attach and tighten the bars to the rails, but I did not get the tool required.
Does anyone know what tool I need to tighten this torque bit/head, to properly attach the square profile roof bars. Where I can purchase? Is it a Volvo trademark tool? Or advice to how to properly attach these bars?
Any help would be appreciated, thanks.
Bookmarks