ABS Sensor Bolt
A couple weeks ago I had the rear wheel bearings replaced on our '03 XC70 by the dealer. All seemed fine until this week when I started getting an intermittant ABS warning message. I put the car on a lift and noticed that the bolt or screw that should have been holding the ABS sensor to the right rear hub was missing. I assume it was either left out or not tightened enough when the hub was replaced. I have put in a bolt of the appropriate length and started the car. The ABS warning message is still present. Are there any special steps that I should have taken when reinstalling the sensor such as lubrication or torque settings that could be at play?
Thanks.
Bill
Bill
63 PV544 (attempted restoration)
83 245 DL OSD (transferred to son)
85 240 GL OSD (transferred to son)
03 XC70 OSD (traded-in 4/12)
05 AWD S80 OSD (transferred to son)
12 XC70 T6
16 S60 T5 Drive-E (FWD)
Bookmarks