Search:

Type: Posts; User: kef

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. I did mention your old post at the beginning of...

    I did mention your old post at the beginning of my post. But thanks!
  2. Closing this thread: I managed to drill out...

    Closing this thread:

    I managed to drill out the old stuck screws and tapping them for new screws. The DEM is finally back on the car. I used a 4.2mm drill bit and and an m5x0.8 tap: Got the...
  3. Thanks for the input, FirstVolvo. I...

    Thanks for the input, FirstVolvo.

    I attempted to remove the bottom longer stud with similar idea but with a vise grip. I gave it a lot of heat, hammered well, but the bolt simply broke off. ...
  4. Ideas removing broken DEM / Haldex bots off - 2005 XC70

    Greetings All,

    I have a 2005 Volvo XC70 at ~260 k miles. Recently, I lost AWD function; I noticed that the rear wheels were not spinning driving in snow. I followed XEMODEX's diagnostic flow...
  5. 2005 XC70 P0089 (ECM-2900) - Problem Persists with New Fuel Pump

    Greetings...

    I recently replaced the fuel pump on my 2005 XC70 at 247 k miles because of a P0089 code (fuel pressure regulator A performance) that would not go away. Yet, the P0089 code still...
  6. Replies
    23
    Views
    4,356

    I had similar 'shaking under load' problem on my...

    I had similar 'shaking under load' problem on my 2002 V70 XC a couple of years back. The fix was replacing the passenger side axle. I went through several axles before a final fix. The problem...
  7. Replies
    37
    Views
    15,537

    Atomic... Any update on your situation? When...

    Atomic... Any update on your situation?

    When my AWD went out (2005 XC70) I had similar experience with yours. I could not control the front wheel spins.
    - First it was due to bad AOC pump. I...
  8. Thread: CCM help needed

    by kef
    Replies
    8
    Views
    6,717

    If the blower fan was working before your last...

    If the blower fan was working before your last activity (oil change and motor mount replacements), I would say go back to those areas you touched or moved and see if you have disconnected a cable or...
  9. Replies
    14
    Views
    3,110

    Can you elaborate on the foaming? Have you tried...

    Can you elaborate on the foaming? Have you tried multiple gas stations (as mentioned by shin91? Gas fill nozzles these days have vapor recovery systems that should take the vapor that escapes the...
  10. Replies
    28
    Views
    11,657

    Success! Happy to say that the new PEM (from...

    Success!

    Happy to say that the new PEM (from Erie) resolved by starting problem.

    Thank you all for your support!

    To summarize:
    The problem: The engine cut-off after about 2 seconds, and...
  11. Replies
    28
    Views
    11,657

    Leto...: Thanks! I've ordered the PEM from...

    Leto...: Thanks! I've ordered the PEM from Erie. Very helpful guys!

    Xfingers: Yes, I can hear the fuel pump before and after cranking. That's what so odd about the fuel delivery problem -- ...
  12. Replies
    28
    Views
    11,657

    Hmmm. I can actually activate the Fuel Pump...

    Hmmm. I can actually activate the Fuel Pump Relay via DICE with a START and STOP activation. As a result, I can hear the pump(s) come on and off. This is a CEM operation. I have attached a...
  13. Replies
    28
    Views
    11,657

    Hoonk: Sorry, I meant to say "relay" rather than...

    Hoonk: Sorry, I meant to say "relay" rather than solenoid. I could activate the relay via DICE as ON/OFF. Thanks for the correction and additional info!

    Now, I'm thinking the fuel pump...
  14. Replies
    28
    Views
    11,657

    X: I think I will do that. I am pretty sure...

    X: I think I will do that. I am pretty sure that I reconnected the 2 tubes and wirings as before (on the right side of the tank). I also made sure that the spring-loaded fuel inlet in left side of...
  15. Replies
    28
    Views
    11,657

    Thanks! Since my starter is engaged, and I...

    Thanks!

    Since my starter is engaged, and I have sparks....

    What prevents fuel from leaving the tank? Fuel pump solenoid does comes on, I can hear pump(s) working, (also new pump assembly). ...
  16. Replies
    28
    Views
    11,657

    Bill, Thx! Yah, the immobilizer. How does...

    Bill, Thx!

    Yah, the immobilizer. How does it really immobilize? How does it affect fuel delivery? How do I reset it!
  17. Replies
    28
    Views
    11,657

    hoonk, the money spent on the fuel pump is very...

    hoonk, the money spent on the fuel pump is very logical as I didn't have any fuel pressure, still don't. And I have sparks at the plugs. Antenna ring had been replaced and DICE has cleared it. I...
  18. Replies
    28
    Views
    11,657

    Well, the battery is less than a year old. When...

    Well, the battery is less than a year old. When the problem first started, the engine cranked very well, started and a couple of seconds later, it stopped. Now, the cranking power is low, and I do...
  19. Replies
    28
    Views
    11,657

    I'm at loss... - I topped the fuel tank with ~...

    I'm at loss...

    - I topped the fuel tank with ~ 1,5 gallons of fuel; still not starting

    - I then replaced the fuel pump assembly; still not starting. Replaced the fuel filter for a good...
  20. Replies
    28
    Views
    11,657

    Interesting. Gas tank is at half way mark per...

    Interesting. Gas tank is at half way mark per gauge on the dash. Since the trickling sound is coming from the left side, would that suggest that the left side tank is empty or something is detached...
  21. Replies
    28
    Views
    11,657

    An update: - The problem appears to be lack of...

    An update:

    - The problem appears to be lack of fuel or fuel pressure in the line. Immediately after cranking the engine, there was no 'spray' when I depressed the schrader valve at one end of the...
  22. Replies
    28
    Views
    11,657

    An update: - Engine is still not starting, but...

    An update:

    - Engine is still not starting, but still cranking. However, at one point "IMMOBILIZER" message came on the dash information panel and stopped the cranking momentarily. I was able to...
  23. Replies
    28
    Views
    11,657

    Thanking you all for your inputs... - The...

    Thanking you all for your inputs...

    - The engine is cranking, the ignition switch side part looks fine. Also current status of CEM-9C03 (Antenna/light ring signal missing) is green now [was red...
  24. Replies
    28
    Views
    11,657

    2005 XC70 Cranks but will not Start

    Hi All,

    My 2005 XC70 at 163 K miles cranks but will not start. When the problem started, the engine started and went off about 2 seconds later. It has not started after that.

    There is no...
  25. Replies
    10
    Views
    2,678

    I would double check if the AWD malfunction is...

    I would double check if the AWD malfunction is indeed due to a bad angle gear or a problem with the Haldex system. It could be the a bad Halex pump as was in my case (also a 2005 XC70, at 132K...
Results 1 to 25 of 73
Page 1 of 3 1 2 3