Search:

Type: Posts; User: volvoxc90bob

Search: Search took 0.00 seconds; generated 46 minute(s) ago.

  1. Replies
    3
    Views
    2,346

    Once you disconnect the shock from the control...

    Once you disconnect the shock from the control arm, you can pull the spring out, but it doesn't get in the way of removing or installing the control arm, so I just left it in it's cradle.

    Two...
  2. Replies
    3
    Views
    2,346

    Once the car is jacked up from the frame, the...

    Once the car is jacked up from the frame, the majority of the tension is relieved from the springs and they did not pose a problem in replacing the front lower control arm.
  3. Replies
    3
    Views
    2,346

    2011 XC60 Rear Trailing arm replacement

    I have new bushing seated in my Ebay purchased used rear trailing arms, I'm heading down to Charlotte, to replace them in my daughter's xc60. I cannot find a single video dedicated to removing the...
  4. Replies
    2
    Views
    2,870

    Thanks Hoonk, I had this posting on a few sites...

    Thanks Hoonk, I had this posting on a few sites before posting here and since I didn't get any feedback on the other sites I ordered a new sensor for less than $100. It was fun removing the old one,...
  5. Replies
    2
    Views
    2,870

    2011 XC60 P0420 Code

    Happy New year to everyone. My 2011 XC60 T6 with 150K miles threw a P0420 code, my hand OBII wouldn't clear the code so I hooked up VIDA and sure enough the ECM fault code "Catalyst System Efficiency...
  6. Replies
    5
    Views
    43,817

    Took to local indy today, the diaphram in one of...

    Took to local indy today, the diaphram in one of the waste gates is shot and you have to replace the whole turbo. $2500 to replace 750 for the part and 9 hours of labor. Of course you have to do...
  7. Replies
    5
    Views
    43,817

    I replaced the plastic pipe, the old one did have...

    I replaced the plastic pipe, the old one did have cracks and the whistle is gone but I'm still throwing the p0234 when I open her up. I hooked a vacuum pump up to the hose that goes to the turbo...
  8. Replies
    1
    Views
    1,980

    I was able to remove the bolt with an easy out....

    I was able to remove the bolt with an easy out. Does anyone have the torque spec for this rear center axle bolt?
  9. Replies
    1
    Views
    1,980

    2004 XC90 Rear axle removal

    I need to replace my rear drivers side axle on my AWD 04 XC90. I don't know how to remove it from the rear differential? Can anyone give me a tip please.
  10. Replies
    0
    Views
    1,721

    2004 XC90 2.9 Rear End Issue

    My 2004 XC90 2.9 started making a weird screeching/grinding noise and it sounds like it is coming from the drivers side rear. I jacked up the rear of the car and the drivers side rear tire does not...
  11. Replies
    5
    Views
    43,817

    Thanks Hoonk, I cleared the code and she stayed...

    Thanks Hoonk, I cleared the code and she stayed off for awhile but she just came back on. I'm going to replace that plastic pipe and report back.
  12. Replies
    2
    Views
    34,377

    I got home today to continue searching for the...

    I got home today to continue searching for the problem with my gear shift, I was going to over ride the shift so I could pull her closer to the garage but did not have to because she shifted without...
  13. Replies
    2
    Views
    34,377

    Will Vida identify the exact cause for the...

    Will Vida identify the exact cause for the message ?
  14. Replies
    2
    Views
    34,377

    2011 XC60 Gear Selector Service Required

    I got in my 2011 XC60 automatic last night and I can't move the gear selector out of park. I also get a gear selector service light on the dash. I have the center console off but I can't tell whats...
  15. Replies
    5
    Views
    43,817

    2004 XC90 2.9 Turbocharger issue

    Yesterday morning my XC90 threw a 0234 code and it feels like the turbo has been disabled. On inspection I can see an oily mix is being sprayed out onto the pipes that lead to the turbocharger as per...
  16. Replies
    12
    Views
    6,379

    I replaced my hoses on the Evap system and I'm...

    I replaced my hoses on the Evap system and I'm not sure if I have the two check valves pointing in the right direction, the check valves have arrows on them indicating direction of airflow. Right now...
  17. Replies
    1
    Views
    1,847

    2004 XC90 2.9 PCV Service

    I am getting ready to service the PCV system on my 2004 XC90 T6 2.9 however all the write ups I see are for the 2.5 engine. Is the procedure identical for the 2.9? If not can someone point me to the...
  18. 2004 Headlight connections melting on both headlights

    Last month the headlight on my 2004 XC90 went out, when I investigated I discovered that the harness was melted where it connects to the bulb. I replaced the harness and everything worked fine for...
  19. Replies
    2
    Views
    13,636

    This forum is rockin

    This forum is rockin
  20. Replies
    2
    Views
    13,636

    Engine light on - 2004 XC90

    The engine light comes on intermittently, the code is 0443.

    Before this code came on I replaced some cracked hoses between the intake and the Evap Purge Valve, and replaced the Evap purge valve...
  21. Replies
    0
    Views
    2,859

    2004 XC90 Code P0496

    My 04 XC90 was throwing a P0496 code, I checked the vacuum and discovered the vacuum to the intake was completely opened up. I replaced this line and the others it connects to and reset the computer....
Results 1 to 21 of 21