Search:

Type: Posts; User: von dutchoven

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    103

    The springs are installed just like the photo in...

    The springs are installed just like the photo in the article. Like I said the pedal doesnít go down when the car is not running even while applying quite a bit of pressure only when the car is...
  2. Replies
    2
    Views
    103

    2005 brake issues

    Our 2005 XC (210k miles) started to having a front end wobble under light to medium braking and the front right rotor was showing signs of chatter so I replaced the pads, rotors and calipers. The...
  3. Replies
    1
    Views
    224

    2005 xc70 wheel compatibility

    My wife just ran our 2005 XC70 into a curb today and screwed up the lip on the front wheel really bad. I havenít actually seen the car yet but from the picture she sent Iíll need to get a new wheel....
  4. Replies
    1
    Views
    400

    2005 with ETM problem?

    The wife's car is a 2005 xc with 206k miles and for the past few of weeks it has been having an intermittent stumble. It is usually on the freeway at a constant speed between 2000 and 2200 rpm . It...
  5. Replies
    15
    Views
    3,321

    I've replaced two timing belts the first without...

    I've replaced two timing belts the first without removing the crank pulley and the second with removing it. it was much easier to do with removal of the pulley. You really do need someway to lock the...
  6. Did I read correctly that the fluid level is at...

    Did I read correctly that the fluid level is at the hot mark when the transmission is cold? Take some fluid out so that its at the cold mark when its cold. I overfilled once and the thing barely...
  7. Replies
    7
    Views
    1,522

    The $300 hose itself is fine it's just the little...

    The $300 hose itself is fine it's just the little plastic line that comes off the banjo bolt that was broken. I found some at the local autozone for $5 and swapped it out. I cleaned the expensive...
  8. Replies
    7
    Views
    1,522

    this line is pretty small. like 1/16" ID. i do...

    this line is pretty small. like 1/16" ID. i do have some braided return line for my old mercedes 240d but even that might be bigger.
  9. Replies
    7
    Views
    1,522

    PCV hose help

    I'm changing the flame trap out today and when I got the intake manifold out I found that the small plastic (vacuum?) line coming off of the banjo bolt was pretty much gone
    82518252
    Has anyone...
  10. Replies
    7
    Views
    1,668

    will do. did you have to replace the pulley?

    will do. did you have to replace the pulley?
  11. Replies
    7
    Views
    1,668

    Thanks that makes thing easier. john

    Thanks that makes thing easier.
    john
  12. Replies
    7
    Views
    1,668

    cam seals

    In a different thread I posted I was wondering about shifting woes and a noisy exhaust valve solenoid on my wife's 2005. While I was looking around I noticed that there was a little oil leaking from...
  13. Replies
    5
    Views
    1,277

    I put in a new battery and she started right up....

    I put in a new battery and she started right up. I drove around to see if it would throw a code or shift poorly. While cold everything was fine but once hot it started to shift pretty hard. I check...
  14. Replies
    5
    Views
    1,277

    Got the car home and pulled the codes. P0027...

    Got the car home and pulled the codes. P0027 exhaust valve solenoid so I don't think that has anything to do with the shifting. The battery is dead so I'm hopeful a new one will fix the shift issue....
  15. Replies
    5
    Views
    1,277

    I did charge the battery and it seemed good plus...

    I did charge the battery and it seemed good plus she drives about 35 miles on the freeway to work. The damage was just a nice long scrape down the drivers side nothing too serious. A women pulled out...
  16. Replies
    5
    Views
    1,277

    2005 shifting problems

    Just got a text from my wife that her 2005 xc is having a hard time finding the correct gear and that the CEL came on. I'm at work so I won't be able to pull the codes until later but Im' just trying...
  17. It is a new sound or at least louder than before....

    It is a new sound or at least louder than before. I can't say I've noticed it in the past. Does this work all the time or just when there is low vacuum? I mean doesn't the engine produce enough...
  18. buzzing sound when brake pedal is drepressed.

    I just changed the pads and rotors on my wife's 2005 xc70 and noticed a buzzing sound coming from the engine compartment. Had her push on the pedal while I poked around and it is coming from what...
  19. Replies
    21
    Views
    5,084

    is it dead like it won't do anything because i...

    is it dead like it won't do anything because i overfilled mine once (not by very much either) and it barley moved. it couldn't figure out what gear to be in and when i drained it and refilled to the...
  20. Replies
    4
    Views
    1,308

    Yesterday I let it idle for about 10 minutes,...

    Yesterday I let it idle for about 10 minutes, turned it off and then checked the oil right away and there were bubbles on the dip stick. I had read this indicates that the o-rings are bad. I should...
  21. Replies
    4
    Views
    1,308

    Yeah I guess that the best place to start. The...

    Yeah I guess that the best place to start. The light and warning message don't come on at idle so that makes me wonder a bit I mean if the pickup was blocked I would think it would do it all the...
  22. Replies
    4
    Views
    1,308

    oil pressure light

    In another thread I asked about P0026 and P0027 codes on my wife's 2005 xc70 with 89k. I fixed that by cleaning the valve solenoids and putting on new gaskets. The screen on the exhaust gasket looked...
  23. Replies
    6
    Views
    1,837

    UPDATE: after sitting for 9 hours i moved into my...

    UPDATE: after sitting for 9 hours i moved into my garage and no valve noise. The CEL is still on.
  24. Replies
    6
    Views
    1,837

    it has not thrown these codes. it seems like they...

    it has not thrown these codes. it seems like they are for both intake and exhaust solnoids.
  25. Replies
    6
    Views
    1,837

    oil level is a bit low but still ok. i was going...

    oil level is a bit low but still ok. i was going to do an oil change this weekend. it's the valve noise that concerns me. it is pretty load. our 2001 has a little bit of valve noise but i think that...
Results 1 to 25 of 63
Page 1 of 3 1 2 3