Search:

Type: Posts; User: Astro14

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    4
    Views
    730

    Quite a story. So, crank bolt came loose and...

    Quite a story.

    So, crank bolt came loose and fell off because it wasnít torqued enough?
  2. Replies
    5
    Views
    149

    I would try bulbs first - they can fail, and you...

    I would try bulbs first - they can fail, and you need the bulbs for the LCD screen to work. If not, it's beyond my abilities, because you're into soldering power supplies, etc. In that case, I...
  3. Replies
    13
    Views
    390

    I don't know the reason for the chamfering. I...

    I don't know the reason for the chamfering. I followed the TSB and the angle gear went from being wet to being dry.

    So, without knowing the reason, I will say that it works.

    At over 250,000...
  4. Replies
    13
    Views
    390

    So...let it blow up? Or fix it for less than...

    So...let it blow up?

    Or fix it for less than the cost of a junkyard unit?

    Remember that the OP merely has a leak. You got a leaking one for $350. So, for $350, you got to where he is now: an...
  5. Replies
    5
    Views
    254

    If I recall correctly, the injectors won't pulse...

    If I recall correctly, the injectors won't pulse unless the ECU registers spark.

    In other words, you can have fuel pressure at the rail, but no fuel going into the car if there is a spark...
  6. Replies
    13
    Views
    390

    This is what you need to do:...

    This is what you need to do: https://www.volvoxc.com/0/resources/how-to/pdf/01-23-09/TNN,%20Drivetrain%20-%20Angle%20Gear%20Fluid%20Leakage.pdf

    $200 in parts, including sleeve and a bit of labor,...
  7. Replies
    9
    Views
    496

    Timing belt is simple, mechanically. Skip the...

    Timing belt is simple, mechanically. Skip the seals if theyíre not leaking. Do the water pump at your mileage. Replace the whole set, including tensioner and idler.

    Some claim to be able to do...
  8. Replies
    9
    Views
    496

    Every timing belt that Iíve done on schedule has...

    Every timing belt that Iíve done on schedule has looked great. If you did the whole timing set (belt, tensioner, idler) on the previous change, this car will likely run for a couple of years before...
  9. When mine tore - I got Volvo factory floor mats...

    When mine tore - I got Volvo factory floor mats to cover the tear...

    https://www.fcpeuro.com/products/volvo-rubber-floor-mat-set-oak-v70-xc70-genuine-39891790

    Perhaps theyíll cover yours?
  10. Replies
    16
    Views
    614

    Those are 3 demanding requirements and I love the...

    Those are 3 demanding requirements and I love the solution. A bit of urban assault vehicle vibe in the look, but itís clean and should work very well.

    Howís the wind noise at highway speed?

    I...
  11. Replies
    7
    Views
    1,645

    Great question - as it looks particularly nice. ...

    Great question - as it looks particularly nice.

    I have had good luck with Wipe New. Prep the surface well (wash and then, I use some mineral spirits to wipe it down) and the Wipe New brings it...
  12. Replies
    4
    Views
    2,483

    No VIN on the motor that Iíve ever found. There...

    No VIN on the motor that Iíve ever found. There is a serial number. Unless youíve got records back 19 years, I donít think youíll ever be certain itís original.

    However, why does that originality...
  13. Replies
    2
    Views
    252

    Well Done!

    Well Done!
  14. Replies
    12
    Views
    991

    Before you can state that the trans is dead, the...

    Before you can state that the trans is dead, the engine must be running properly and the fluid level must be accurate.

    If you’re measuring and saying you got 4 Liters out of it, or 2, then you...
  15. Unless you fixed the flame trap/PCV pressure that...

    Unless you fixed the flame trap/PCV pressure that caused this seal to fail, it WILL fail again.

    Your fix wonít last until the underlying problem (crankcase pressure) is resolved.

    Read my...
  16. Replies
    13
    Views
    3,121

    Great! If the glue doesnít hold, a new charge...

    Great!

    If the glue doesnít hold, a new charge air pipe is still available.

    Iím glad you solved the problem.

    Cheers,
    Astro
  17. Replies
    9
    Views
    2,550

    If you find yourself having to re-do your work...

    If you find yourself having to re-do your work (like an improperly installed timing belt) then, yeah, theyíre high maintenance.

    The cars in question are between 13 and 19 years old.
    ...
  18. Replies
    7
    Views
    1,645

    That looks great! Nicely done!

    That looks great! Nicely done!
  19. Replies
    17
    Views
    5,495

    I appreciate the update. Thanks. I did the...

    I appreciate the update. Thanks.

    I did the IPD inserts on the XC at about 180,000. The car is developing a few clunks now and then and I fear that this repair is in my near future....
    ...
  20. Replies
    4
    Views
    1,785

    Love the flush adapter - I should've thought of...

    Love the flush adapter - I should've thought of that!

    You'll find the crush washer to be the same size as the oil drain plug crush washer, so, you can buy them in bulk from a place like IPD and...
  21. Thread: Vibration

    by Astro14
    Replies
    8
    Views
    2,632

    If youíve got play in that outer CV joint, then...

    If youíve got play in that outer CV joint, then the axle is worn out. Itís the source, or very likely the source, of your vibration.

    Donít go with rebuilt axles. They all suck and will vibrate...
  22. Replies
    4
    Views
    1,631

    I've not mounted a bull bar on this, or any...

    I've not mounted a bull bar on this, or any other, car, including my trucks.

    If you're looking to mount it to the frame, then remove the bumper cover, and you'll see the aluminum crossbar as well...
  23. Replies
    3
    Views
    1,443

    Well, I've yet to see a crack on my XC, which at...

    Well, I've yet to see a crack on my XC, which at over 250,000 has the most miles of my P2 Volvos. I would recommend the IPD couplers, and a careful inspection of your charge air pipe. Be forwarned...
  24. Replies
    2
    Views
    1,484

    With any tune, be certain that the rest of the...

    With any tune, be certain that the rest of the fuel delivery, ignition and transmission are up to the increased power.

    I would put in new plugs, check everything, change the oil, and the...
  25. Googling suggested that I have terminal cancer. ...

    Googling suggested that I have terminal cancer.

    But a couple of Tums cured my symptoms, so...

    Look, you really need to do some more troubleshooting, which must include testing, on this. A code...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4