wiring component illustrations has it as 10/161. but I cannot find it on Group 35 lighting diagram

look down to see any leaking from them. mine had leaked.

Can anyone provide link for a version of Vida to load on xp machine?

New Volvo front calipers put on in 2018 on my 2007 xc70. Old calipers were causing uneven pad wear.
When I replaced front pads in 2020 there was some of this corrosion starting and I contacted...

I have Volvo Workshop EPC and WDS on dvds. Are they standalone programs or do they get absorbed into VADIS?

I think that worked for my 2001 car but I cannot seem to get this off for my 2007

2007 xc70
I am stumped. How do you remove this from back of front seat rail?

Yes. I did not see the hole for the snap in.

2007 V70 XC ABS cable harness duct on front passenger side up against the firewall on far right side is just hanging
where does it attach?

what is the vacuum pump for, the brake booster? why not just pull vac like other cars?
i found the vacuum pump in VADIS. where is the switch? thanks

my vadis only goes to 2005, is there a...

I did a search for whine and nothing relevant turned up.
Just this morning a new noise began. It is a rather high pitched whine coming from the silver module located down below air cleaner box....

redundant

I just upgraded from a 2001 to 2007 xc70. Took off hitch and harness from 2001 to put on 2007. Oops, 2007 is now all CAN, so I had to buy the new harness and a module.

So I have a wiring harness...

Just bought this 2007 xc70 after 2nd tranny died on my 208k mile 2001 xc70. anyone recognize this holder?

2001 xc70

The boots on my coils are drying out. Anyone know the maker part number for them before I have to yank one out to find it?

157K miles

It feels like bad misfire or suddenly the injector got bad fuel.

We were driving on highway ~65-75 mph and there was a stutter from the engine. Happened about 4 time in 8 hours. No codes came back.
I cleaned the throttle body two months ago, also new plugs.
...

I was browsing for a different item and saw this thread. I used the volvo washer pieces on my porsche....

I had the check engine light come on and had codes p0236 and P0237, so replaced the MAP sensor and everything is fine. I have original ETM at 150k miles and was wondering about it after I started...

How do you replace that sensor?

http://www.volvoxc.com/resources/how-to/pdf/replacing-control-arm-bushings.pdf

but I separated the shock from the spindle, only way I could have movement to clear ball joint

then use rope if...

updated information


http://www.volvoxc.com/resources/how-to/pdf/replacing-control-arm-bushings.pdf

So I am doing all the brakes and changing the front lower control arms.
Here are the tightening torques I have found
XC70 bolt torques
brakes
locating pin 8 NM
sliding pin in brake caliper 30...