Search:

Type: Posts; User: goldxc70

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Old thread I know, but here's my two cents: You...

    Old thread I know, but here's my two cents:
    You can use pretty much any scantool to check the MAF sensor on your car. There are YouTubes describing in detail. I had a bad MAF in a 2004 XC70 and...
  2. Replies
    8
    Views
    1,494

    I use a smear of conductive grease, or electrical...

    I use a smear of conductive grease, or electrical contact grease, on bulbs and contacts. In my experience, it helps especially with rear lights.
  3. Replies
    4
    Views
    1,238

    How was your PCV system? Was it gummed up? I did...

    How was your PCV system? Was it gummed up? I did mine recently and it was pretty bad but the intake manifold was evenly clean. However, my assistant commented on the #1 and #2 cylinder vale stems...
  4. One easy way to get the broken nozzle out is to...

    One easy way to get the broken nozzle out is to screw in a small wood screw, and, when it grabs, withdraw it with a pliers.
  5. Replies
    3
    Views
    1,057

    Side mirrors from 2003/4 - 2007 are...

    Side mirrors from 2003/4 - 2007 are interchangeable, I believe.
  6. Not worthy of a response!

    Not worthy of a response!
  7. That's got to be one of the "most dumb &...

    That's got to be one of the "most dumb & worthless" comments I've ever read on this site.
  8. Replies
    70
    Views
    122,252

    There isn't one on my MY04.

    There isn't one on my MY04.
  9. Replies
    3
    Views
    1,506

    Congratulations on your new (to you) XC70. ...

    Congratulations on your new (to you) XC70.

    As NTXC said below, the alarm message is usually to do with the battery failing in the alarm module which is under the fender liner in the passenger...
  10. Replies
    5
    Views
    5,334

    I think the old style has an o-ring as well but...

    I think the old style has an o-ring as well but it's "contained" inside the fitting. If my memory serves .... it's a few years since I changed the fitting.
  11. Replies
    0
    Views
    847

    "Chirp" from passenger side, rear

    Heard this "chirping" sound from rear, passenger side. Observed that it was road speed related so drive train or hub related. Removed (with some difficulty) rotor/drum and immediately saw this.
    ...
  12. Replies
    5
    Views
    5,334

    Here:...

    Here: https://www.ipdusa.com/products/7754/115619-fuel-rail-line-disconnect-coupler-fitting-genuine-volvo-30677229

    I changed mine from the old to the new style a few years ago as I suspected a...
  13. In my case, it was "CEM-1A5F Communication with...

    In my case, it was "CEM-1A5F Communication with BCM control module Signal missing" that pointed the electronic repair tech to the ABS module. The repair was CAD190 here in Toronto.
  14. Not every condition causes a trouble code to be...

    Not every condition causes a trouble code to be generated. A couple of years ago, I had a fuel pump issue that starved the engine and caused it to stutter and nearly stall occasionally. No codes at...
  15. Plugs and coils would also be my first stop.

    Plugs and coils would also be my first stop.
  16. Symptoms sound very similar to mine a few years...

    Symptoms sound very similar to mine a few years back. In my case, it was the ABS module (as hoonk mentions below) which I got repaired locally here in Toronto. There is no problem driving the car...
  17. Replies
    7
    Views
    2,241

    Did my passenger side half shaft/axle recently...

    Did my passenger side half shaft/axle recently after discovering damage to inner CV boot. It was a very straight forward job and took no more than about two hours. I was prepared for some leakage...
  18. Replies
    3
    Views
    105,214

    Remember looking into this a few years ago and...

    Remember looking into this a few years ago and could find only one dealer in Toronto doing it. Unfortunately, I cannot remember who that was! At the Toronto Autoshow this year, I was chatting to a...
  19. Changed mine (MY2004) just last week and found it...

    Changed mine (MY2004) just last week and found it it where I expected to see it - on passenger side under fender liner mounted up high.

    Re fender liner, I just drilled the five rivets towards...
  20. I don't remember having any problem with the top...

    I don't remember having any problem with the top mount when I did my rear shocks last year. The only alignment was that both ends of the spring are supposed to point in the same direction (in, I...
  21. Replies
    8
    Views
    1,549

    Doesn't sound like turbo lag to me. Is it a...

    Doesn't sound like turbo lag to me.

    Is it a new thing since the other work was done?
  22. I went the Sensen unistrut route a few years ago...

    I went the Sensen unistrut route a few years ago on the front for convenience. They were a complete waste of time and I replaced them two years later with individual parts. If you are up for doing...
  23. Replies
    13
    Views
    4,132

    OK, we're saying the same thing but I just got my...

    OK, we're saying the same thing but I just got my left mixed up with my right! Which, of course, is why my regular passengers point when giving me directions.
  24. Replies
    13
    Views
    4,132

    Changed both front a few years back but made no...

    Changed both front a few years back but made no difference to that noise at all.

    Also, with bearings, I thought the noise came from loading the bearing and when unloaded it went away.
  25. Replies
    13
    Views
    4,132

    Did your noise change depending on which way you...

    Did your noise change depending on which way you steer? I have a noise (at highway speeds) that almost completely goes away when I steer to the left, comes back when I straighten up again or steer...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4