Search:

Type: Posts; User: bartk

Search: Search took 0.00 seconds.

  1. Replies
    9
    Views
    1,781

    Front also done if I would make the spaccer...

    Front also done if I would make the spaccer bigger it will get very difficult to install,
    almost can't push the suspension arm down any more, Good thing is that the arm is not hitting
    the...
  2. Replies
    9
    Views
    1,781

    you could use that for the rear, the problem is...

    you could use that for the rear, the problem is that the front has a small travel adding these in the front would reduce the travel down linear, that is why I put the spaccer on top of the strut
  3. Replies
    9
    Views
    1,781

    finally some good weather. installed the back 3D...

    finally some good weather. installed the back 3D printed spaccer.
    IT looks good

    8940
  4. Replies
    5
    Views
    1,560

    rear lift with one jack at 33 sec ...

    rear lift with one jack at 33 sec


    https://youtu.be/uZNC06Z7imQ?t=34
  5. Replies
    9
    Views
    1,781

    The way that I want lift it it is possible to...

    The way that I want lift it it is possible to lift a Nivomat XC/V70, I only fill the spring, but it is not so difficult to also do the same for the shock,
    The only thing is that you should make...
  6. Replies
    9
    Views
    1,781

    Lifting XC70 2012 in 2 stages :-)

    Hi all

    I would like to share my experiences in lifting the my XC70 2012. Until now I like the looks of it.

    Stage 1
    I bought 235x60x17 ( 5% higher wall ) Cooper WeaterMaster WSC. Don't Advice...
Results 1 to 6 of 6