Search:

Type: Posts; User: ericjp

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    5
    Views
    2,702

    Yeah, that was the module I replaced the relay...

    Yeah, that was the module I replaced the relay in. I'd have to go look again to see which particular slot it was in, but most likely you're right.
  2. Replies
    5
    Views
    2,702

    I had power at the fuse panel for the DIM and...

    I had power at the fuse panel for the DIM and followed the wiring back to a module that had a bunch of relays. I don't know if it was the CEM or not. I found a bad relay by wiggling them...
  3. Replies
    5
    Views
    2,702

    Just an update, the problem ended up being a...

    Just an update, the problem ended up being a relay to the right of the fuse panel on the drivers side
  4. Replies
    5
    Views
    2,702

    2002 v70 xc no dim or hvac

    Had been having intermittent function from both dim and HVAC. Sometimes would only take a second from starting the car until they came back up. Drove home today and they never came back up. I...
  5. Thread: Fyi

    by ericjp
    Replies
    2
    Views
    1,167

    Crazy, even for low mileage.

    Crazy, even for low mileage.
  6. Replies
    12
    Views
    2,986

    12.2 is too low. What was the voltage with it...

    12.2 is too low. What was the voltage with it running? Should be around 14 volts.
  7. Replies
    12
    Views
    2,986

    Assuming the battery isn't bad, wiggle the wire...

    Assuming the battery isn't bad, wiggle the wire for the starter solenoid. Sometimes they get corroded and don't make a good connection.
  8. Replies
    15
    Views
    4,447

    "hard pull to the left when I apply the brake" ...

    "hard pull to the left when I apply the brake"

    I had a hard pull to the left when I had a bad rear bushing in a control arm. Just another possibility.
  9. Does it come on if the AC is on? I'm not sure if...

    Does it come on if the AC is on? I'm not sure if there's a fuse for the ECM that controls the fan.
  10. If you still have the old fan plug it back in and...

    If you still have the old fan plug it back in and see if it comes on. If it does then you know the main power is good, and the only other issue is if it's not getting a signal to turn on. Always a...
  11. The shift button is able to be pried out without...

    The shift button is able to be pried out without too much effort. Local junkyard is a good place to look. or...
  12. You should be able to just swap the leather seat...

    You should be able to just swap the leather seat cover. Just undo all the hog rings
  13. Top of transmission, looks like a large 5 sided...

    Top of transmission, looks like a large 5 sided bolt.
  14. Replies
    15
    Views
    4,447

    Depends on gow would you describe a wiggle? If...

    Depends on gow would you describe a wiggle? If guess worn front axles if it's under acceleration.
  15. Replies
    14
    Views
    4,140

    How did you flush the fluid? Gibbons method, or...

    How did you flush the fluid? Gibbons method, or just drain and fill? The transtune does work on varnish to a degree.
  16. Replies
    42
    Views
    34,858

    I agree with astro14, the intake system is...

    I agree with astro14, the intake system is probably full of oil still.
  17. Replies
    42
    Views
    34,858

    Change the cylinder that the #5 coil is on when...

    Change the cylinder that the #5 coil is on when reinstalling. See if the misfire follows it.
  18. Replies
    42
    Views
    34,858

    Was the oil just burning past the turbo, or was...

    Was the oil just burning past the turbo, or was it making it way through your intake system? Pull that #5 plug and take a look at its condition.
  19. Replies
    42
    Views
    34,858

    You should be able to pull off the inlet to the...

    You should be able to pull off the inlet to the turbo and feel for shaft play in the turbine itself. You'll be able to see if it's leaking in the oil out of seals as well.
  20. Thread: Brake booster

    by ericjp
    Replies
    1
    Views
    764

    If you pull the boot on brake pedal shaft back,...

    If you pull the boot on brake pedal shaft back, you'll see a while tube. I had the same whistle air leak and lubricated the outside of the tube with silicone grease which took care of it. ...
  21. Replies
    10
    Views
    6,032

    I've also had an alternator that would charge...

    I've also had an alternator that would charge until it got hot. When first started it'd charge, but 15 minutes later it wouldn't.
  22. Replies
    10
    Views
    6,032

    Did you check the battery voltage with a meter? ...

    Did you check the battery voltage with a meter? That'd tell you if your battery is getting charged.
  23. Replies
    5
    Views
    2,312

    I think that is what I was referring to. I just...

    I think that is what I was referring to. I just need to find a new one. Thanks for the info.
  24. Replies
    5
    Views
    2,312

    Just went thru this same thing last night, but I...

    Just went thru this same thing last night, but I was getting 5 codes instead of 3. Searched the net and found that there is a sensor in the air intake hose right before the turbo where the pcv lines...
  25. Replies
    4
    Views
    1,408

    Good write up. Hopefully there wasn't any damage...

    Good write up. Hopefully there wasn't any damage from the low oil pressure.
Results 1 to 25 of 91
Page 1 of 4 1 2 3 4