Search:

Type: Posts; User: ssicarman

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds; generated 15 minute(s) ago.

  1. I would suspect corrosion in a connector/damaged...

    I would suspect corrosion in a connector/damaged wiring harness. By the time you noticed a leak it could have been happening for a long time and caused problems. With low voltage CAN (the...
  2. Replies
    26
    Views
    1,915

    Have you checked the axles? Broken, stripped...

    Have you checked the axles? Broken, stripped splines at the wheel bearings, not in the transmission all the way.

    Better yet when you put the car into park are you able to make it move/roll by...
  3. Replies
    3
    Views
    673

    Glad that you found it. Had mine go bad in 2016...

    Glad that you found it.
    Had mine go bad in 2016 on vacation. Post 25 shows pictures.

    ...
  4. Replies
    8
    Views
    773

    Whole sensor. I have yet to see a tire pressure...

    Whole sensor.
    I have yet to see a tire pressure sensor that has replaceable batteries. I have worked for three dealers, different brands and no sensors can be opened. They are sealed to be able to...
  5. Replies
    6
    Views
    649

    As with all things automotive there is an...

    As with all things automotive there is an exception to pretty much every rule.

    Normally the front of the engine (cylinder 1) is going to be at the opposite end from the transmission. V engines...
  6. The key can be manually pulled out. It is a hard...

    The key can be manually pulled out. It is a hard pull because you are working against the motor for the key. Once you get it out check inside the opening for debris in the key hole. There are black...
  7. Replies
    1
    Views
    1,072

    Have you tried a phone/ipod type device in the...

    Have you tried a phone/ipod type device in the USB port rather than just a flash drive?
  8. Considered using a hose clamp to secure the...

    Considered using a hose clamp to secure the bracket to the strut?
  9. Replies
    15
    Views
    1,330

    Power at the fuse..... Did you check for power...

    Power at the fuse.....

    Did you check for power and ground at the bulb connector? Use an an old school test light with a bulb.
    A multi meter or an electronic test light can fool you. These will...
  10. Headlamp switch is in the on position? If it is...

    Headlamp switch is in the on position?
    If it is not turned to the headlamps on then all you will get by pulling the lever back is the flash to pass from the high beams.
  11. May I missed it but is the coolant level going...

    May I missed it but is the coolant level going down? Are you having to add coolant?

    Terminology correction (pet peeve and less confusion caused). The AC evaporator is in the HVAC box in the car...
  12. Replies
    9
    Views
    913

    I suspect that that would be a bad idea. The...

    I suspect that that would be a bad idea. The system is supposed hold pressure in it after it is shut off. If it is dropping to zero with in minutes there is a problem.
  13. Is the driveshaft/propeller shaft turning?

    Is the driveshaft/propeller shaft turning?
  14. Replies
    8
    Views
    880

    No it can't.

    No it can't.
  15. Replies
    11
    Views
    1,980

    You want to check for the draw to make sure that...

    You want to check for the draw to make sure that you don't have a system pulling the battery down. If no draw then you get to start trying other things.

    Any newer DVOM should have an amp setting...
  16. Replies
    11
    Views
    1,980

    In all of this have you checked for a parasitic...

    In all of this have you checked for a parasitic draw?
  17. Replies
    1
    Views
    365

    US and Canada there is a sticker on the drivers...

    US and Canada there is a sticker on the drivers door opening, body side, with the VIN and build date. It would be the month and then year of when the car was built (four digit code, first two are the...
  18. Replies
    2
    Views
    531

    Is the ball/swan neck removable from the main...

    Is the ball/swan neck removable from the main body of the hitch? If so I would think that the ball would have a fairly standard size mount to the main body. If so then try looking at other...
  19. Replies
    4
    Views
    859

    Very good point. A clogged cabin filter will can...

    Very good point. A clogged cabin filter will can cause odd blower noises as the blower needs to work harder than it should.

    A couple of weekends ago I spent a fun filled afternoon plus replacing...
  20. If pushing the hood down makes the hood release...

    If pushing the hood down makes the hood release easier then something is pushing the hood upwards harder than is needed. There will be something to adjust bump stops/adjusters for the hood. Lowering...
  21. The piece in the pictures is not a torx. It is an...

    The piece in the pictures is not a torx. It is an eight point/double square/eight spline. If the lock piece does not come out and then turn the head you should be able to find a socket that will fit....
  22. A picture would be very helpful.

    A picture would be very helpful.
  23. Replies
    4
    Views
    552

    Out of curiosity when you plugged your VIN in did...

    Out of curiosity when you plugged your VIN in did it come up with any recalls?
  24. Replies
    4
    Views
    552

    Two minutes (barely) of googling...... ...

    Two minutes (barely) of googling......

    https://www.volvocars.com/us/own/additional-choices/recall-information
  25. Replies
    18
    Views
    1,905

    Dump a gallon or so of fuel in the tank and see...

    Dump a gallon or so of fuel in the tank and see if it starts.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4