Search:

Type: Posts; User: andybbrown

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. Replies
    7
    Views
    20,072

    would be good to know though

    would be good to know though
  2. Replies
    53
    Views
    24,886

    But it is a fix that can do in an afternoon. I...

    But it is a fix that can do in an afternoon. I used a hacksaw blade to cut mine open. Bro-in-law soldered the pins, Stuck together with that sticky rtv? stuff. Works well.
  3. Replies
    6
    Views
    2,742

    Sounds like my vehicle, I've got a camshaft...

    Sounds like my vehicle, I've got a camshaft position sensor coming, yet I still have the pin of coolant reservoir hose at the radiator snapped off, as well the same clunk as your one. It is a wonder...
  4. Replies
    12
    Views
    24,555

    It's worth it to do the bevel gear and diff oil....

    It's worth it to do the bevel gear and diff oil. It adds much more torque.
    Get the right oil, not just any axle oil. Suck out old. Squeeze in new until it starts to trickle/stream out. Block with...
  5. Hope it went well ...

    Hope it went well ...
  6. Replies
    12
    Views
    24,555

    I wouldn't go the route into transmission...

    I wouldn't go the route into transmission suggested by the author, use the dipstick tube which is also the fill using a funnel.
    There have been noted problems removing the wrong bolt from the top...
  7. Replies
    4
    Views
    9,121

    To tighten e brake at the shoes turn the cog...

    To tighten e brake at the shoes turn the cog (shown in photos) towards the front of vehicle, to loosen brake shoes turn the cog back. You will hear the spring as it sits on the cog as every time the...
  8. Replies
    10
    Views
    12,106

    I read when getting the inlet manifiold off a 99...

    I read when getting the inlet manifiold off a 99 XC you take the three torx bolts and remove the runner and that undoes the plug so don't have to disconnect the fuel line to remove IM. So, don't need...
  9. Replies
    10
    Views
    12,106

    Thanks

    Thanks
  10. Replies
    35
    Views
    26,542

    Great write up and pictures.

    Great write up and pictures.
  11. Replies
    6
    Views
    2,042

    That's interesting about tread tolerances. I had...

    That's interesting about tread tolerances. I had two new tyres put on and a few days later had a noticeable driveshaft vibration. Actually there was a nasty shudder as well. But, it went away. The...
  12. Poll: That's right. "Brake failure, stop!" and "Oh no,...

    That's right. "Brake failure, stop!" and "Oh no, dust in your etm!" and "Wheel sensor on left needs checking," and "Motronic connection to the Engine management system has failed," to "Yes, we...
  13. Replies
    10
    Views
    12,160

    https://app.box.com/shared/cjh7pkl0cs Awesome...

    https://app.box.com/shared/cjh7pkl0cs
    Awesome write up and photo instructions, and includes the turbo, too!
    Just a few changes. I took out the dipstick, much more room for a TB screw and removing...
  14. Replies
    8
    Views
    6,100

    Is it strickly necessary to replace gasket? Can I...

    Is it strickly necessary to replace gasket? Can I make one with instant stuff or gasket card?
  15. I know it sits inside of the pressure bowl thing....

    I know it sits inside of the pressure bowl thing. From memory when I sat it in the threaded part, I hoped it wouldn't get pushed into the big bowl thing. But when I pressed in the position sensor I...
  16. Replies
    20
    Views
    3,739

    5827 Yaay. I could not see with my eyesight and...

    5827
    Yaay. I could not see with my eyesight and viewing angle there was a W letter at the beginning of all that.
    A little advice sure can pay off.
    I can see from looking at the chart the correct...
  17. Replies
    20
    Views
    3,739

    This thread matches my problem: 5808 Using...

    This thread matches my problem:

    5808

    Using Swedishautoparts there seem to be four types of springs each coloured differently and codes that go with each spring. The first two digits of the...
  18. Replies
    6
    Views
    4,906

    sMALL Update

    I towed a heavy trailer. Soon after the shudder and codes that were felt rhoughout the car, and the codes making the transmission light flash, stopped. For one full day stretching to three now with...
  19. Replies
    6
    Views
    4,906

    Thanks for the reply and the link:...

    Thanks for the reply and the link: https://www.midwest-abs.com/Troubleshooting.php to the Midwest ABS module site.

    I had resoldered a pair of two large pins, one of which had cracked, in the...
  20. Replies
    6
    Views
    4,906

    What happened? My car has same codes.

    What happened? My car has same codes.
  21. Fuel door stopped - back hatch (Wagon) click, click no open

    I wonder how these two are linked - the fuel door catch stopped so pried open and held with magnets now, and stopped with no warning and doesn't go click, at the very same time the rear door unlocker...
  22. Replies
    3
    Views
    1,568

    Thanks. I went to partsforvolvo.com and that was...

    Thanks. I went to partsforvolvo.com and that was great.
  23. Haha That is soo good though now because it was...

    Haha That is soo good though now because it was an easy fix.
  24. Replies
    10
    Views
    3,513

    Without ice around what is the easiest way to...

    Without ice around what is the easiest way to test if it is AWD or not? I try spinning it up on gravel but except for a little spin on maybe one tire the tires just connect to the ground.
  25. Replies
    11
    Views
    3,615

    Awesome video. Many thanks. Isn't it a bit odd...

    Awesome video. Many thanks.

    Isn't it a bit odd that the air to the throttle doesn't seem to come from after the air filter?
Results 1 to 25 of 56
Page 1 of 3 1 2 3