PDA

View Full Version : Brake bulb - wire harness help



jmoser
03-08-2007, 07:29 AM
Had to replace the brake light bulb, driver's side [US.] This is the one where you remove the speaker and the bulb is just below the opening. Right above the offending bulb is a gray wiring connector that I could NOT figure out how to remove. I even tried using an inspection mirror to see if the release was on the far side but could not tell. VERY hard to reach and hold the plastic bulb holder with this connector in the way.

Is there a trick to removing this connector? Is it a special tool or is it just hard to see and reach ? ? ? They must be kidding with that design.

I hate Volvo lights and bulbs - way too many burnouts and way too difficult to change.

Any help is appreciated.