Rellinn
02-24-2018, 07:13 AM
Hi all,
I have a problem with my ETM module. Have diagnosed with Dice and also iCarsoft tool.
got code 284: ECM-9150 Throttle position (TP) sensor 1. Faulty signal
372: CEM-1A5D Communication with the electronic throttle module (ETM). Signal missing
There are new sensors on both sides
I have also measured the voltage of the module (1 is three pin side and 2 is five pin side)
GND – 1-0,01 volts, 2-0,02volts
Vss – 1-5,03 volts, 2-5,02
Voutput @ default throttle position – 1-1,42volts, 2-1,49volts
Voutput @ closed throttle position – 1-0.61 volts, 2-0,66volts
Voutput @ full open throttle – 1-4,62volts, 2-4,66volts
With iCarsoft tool I can do live stream data on the ETM and it show 108 degree on potentiometer 1 and potentiometer 2 is shoving normal behavior.
the problem seems to be the connection between ETM and ECM through pin 3 and 4
Is my ETM module bad or do I have some other issues? Has anyone encountered this problem?
thanks
I have a problem with my ETM module. Have diagnosed with Dice and also iCarsoft tool.
got code 284: ECM-9150 Throttle position (TP) sensor 1. Faulty signal
372: CEM-1A5D Communication with the electronic throttle module (ETM). Signal missing
There are new sensors on both sides
I have also measured the voltage of the module (1 is three pin side and 2 is five pin side)
GND – 1-0,01 volts, 2-0,02volts
Vss – 1-5,03 volts, 2-5,02
Voutput @ default throttle position – 1-1,42volts, 2-1,49volts
Voutput @ closed throttle position – 1-0.61 volts, 2-0,66volts
Voutput @ full open throttle – 1-4,62volts, 2-4,66volts
With iCarsoft tool I can do live stream data on the ETM and it show 108 degree on potentiometer 1 and potentiometer 2 is shoving normal behavior.
the problem seems to be the connection between ETM and ECM through pin 3 and 4
Is my ETM module bad or do I have some other issues? Has anyone encountered this problem?
thanks