BillAileo
07-05-2007, 06:25 PM
A couple weeks ago I had the rear wheel bearings replaced on our '03 XC70 by the dealer. All seemed fine until this week when I started getting an intermittant ABS warning message. I put the car on a lift and noticed that the bolt or screw that should have been holding the ABS sensor to the right rear hub was missing. I assume it was either left out or not tightened enough when the hub was replaced. I have put in a bolt of the appropriate length and started the car. The ABS warning message is still present. Are there any special steps that I should have taken when reinstalling the sensor such as lubrication or torque settings that could be at play?
Thanks.
Bill
Thanks.
Bill