Search:

Type: Posts; User: Aviator

Page 1 of 20 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    10
    Views
    2,850

    "So, the 2013 AWD saddle tank has 2 level...

    "So, the 2013 AWD saddle tank has 2 level senders, one on each side?...the left side sender welded into the tank?"

    Yep! All Volvo saddle tanks have a level sender on each side.

    "Still learning...
  2. You need to get the car on a hoist with someone...

    You need to get the car on a hoist with someone in it to "drive" it, while someone is underneath listening for where the noise is coming from. Which wheel bearings did you replace?
  3. Replies
    10
    Views
    2,850

    "I'm perplexed because everything I'm seeing in...

    "I'm perplexed because everything I'm seeing in online documentation for 2013 XC70 AWD "saddle" fuel tank indicates a single portal (fuel pump and level sender integrated into the same assy."

    That...
  4. Replies
    10
    Views
    2,850

    The sender on the left side of the tank gets...

    The sender on the left side of the tank gets fouled with dirt and starts to stick or break. There is no access to that part of the tank...only the right side where the fuel pump is. Also, the plastic...
  5. Replies
    10
    Views
    2,850

    The fuel level sender in the left side/ejector...

    The fuel level sender in the left side/ejector side of the tank is shot. You need a new fuel tank.
  6. Thread: turbo oil leak

    by Aviator
    Replies
    7
    Views
    6,483

    More than likely, the banjo bolt that holds the...

    More than likely, the banjo bolt that holds the oil supply pipe to the top of the turbo, has loosened off. This will make oil piss out all over the back of the engine and then undercoat the bottom of...
  7. Replies
    3
    Views
    2,261

    Volvo doesn't make "winter" wiper blades.

    Volvo doesn't make "winter" wiper blades.
  8. You need a new turn signal stalk. This is a...

    You need a new turn signal stalk. This is a fairly common issue with the P3 XC70s. It's plug and play....no programming needed.
  9. Replies
    6
    Views
    1,323

    It goes on the end of the long bolt that goes...

    It goes on the end of the long bolt that goes through the top engine mount.

    Dave.
  10. Replies
    3
    Views
    1,035

    I asked because it may be your trailer lighting...

    I asked because it may be your trailer lighting or wiring that's causing the issue. ;)

    Dave.
  11. Replies
    19
    Views
    3,244

    Good to hear it's sorted out for you. Dave.

    Good to hear it's sorted out for you.

    Dave.
  12. Replies
    6
    Views
    1,659

    Probably the sway bar links are worn out. They...

    Probably the sway bar links are worn out. They either get a lot of play in the lower ends, or they go "dry" inside the ends and end up making creaking sounds. I'd start with those first. Also. lately...
  13. Replies
    2
    Views
    1,122

    Behind the bumper cover is what's called the rear...

    Behind the bumper cover is what's called the rear section in which the "attaching plates" are held. These are what you are describing, and they can be purchased seperately from the rear section. Left...
  14. Replies
    3
    Views
    1,154

    There's no set way to take the pan down. I try to...

    There's no set way to take the pan down. I try to lower the transmission end a bit and feed the pan down on an angle and then straight down. The mouth of the oil pickup will catch in the pan. Just be...
  15. Replies
    8
    Views
    4,806

    Front to back is the correct way, however, Volvo...

    Front to back is the correct way, however, Volvo doesn't recommend rotating tires now.

    Dave.
  16. That's a healthy PCV system!! Dave.

    That's a healthy PCV system!!

    Dave.
  17. Replies
    8
    Views
    6,493

    What did you test the BCM with?

    What did you test the BCM with?
  18. Replies
    3
    Views
    1,035

    Could be a problem with the socket and/or the...

    Could be a problem with the socket and/or the lamp assembly. If the socket isn't seating right on its contacts, it will arc at the voltage contact and that will pop a fuse as well. I believe you also...
  19. You don't know that for sure though. You could be...

    You don't know that for sure though. You could be at -.2kPa which is the threshold for PCV overhaul. You could even be at -.3kPa. See, that's the importance of using a tool that has units of...
  20. That's correct. The tube sinks into the top of...

    That's correct. The tube sinks into the top of the pan by about 10mm. The stick extends beyond the bottom of the tube, and dips into the oil in the pan.

    Dave.
  21. Never any at the top hole in the block. It's a...

    Never any at the top hole in the block. It's a much bigger hole than the lower one. You might see a little bit of crud hanging around it; just scrape it away and wipe the hole....kinda like wiping...
  22. Replies
    19
    Views
    3,244

    You're welcome. I'm not sure that you can get the...

    You're welcome. I'm not sure that you can get the deflector on its own though as a stand alone part; pretty sure it only comes in the bearing kit.

    Dave.
  23. Replies
    2
    Views
    908

    Dealer item....PN 9171544. That's the control...

    Dealer item....PN 9171544. That's the control mechanism closest to where the heater core is.

    Dave.
  24. Replies
    8
    Views
    6,493

    From your information it sounds like you need a...

    From your information it sounds like you need a new BCM (brake control module), plus software. I highly doubt there is an issue with a speed sensor in the transmission.

    Dave.
  25. Replies
    20
    Views
    10,796

    It's quite easy to get in on that bolt by using...

    It's quite easy to get in on that bolt by using 1/4" drive ratchet, 10" extension, and short 6 point 10mm socket. It only needs to be loosened a little bit, and the manifold will come right off....
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4